View Single Post
Old 02-22-2010, 12:54 PM   #48
SupaHottSauce
Scooby Specialist
 
Member#: 111725
Join Date: Apr 2006
Chapter/Region: MWSOC
Location: Hillside, IL
Vehicle:
2003 Dylan Peterson
is a scammer

Default

Quote:
Originally Posted by OUScooby View Post
The bar has four mounting points, two below the bumper bolted to the frame (I think it's the same spots where the rally innovation light bar mounts, and two more in the lower grill on the radiator support. I still need to reinforce the radiator support as if I were to actually hit anything with it it would rip out the tin the radiator support is made of and probably puncture my radiator.
The bar is made of stainless steel, my original idea was to powdercoat it black, but when the fabrication was done and I bolted it on, I liked the shiny look the steel had, and decided to have it polished. The only downside is that even though it's polished it still tarnishes slightly when it gets rained on, which means I have to clean it up with some polishing compound every time it rains (Good thing it almost never rains here in SoCal). I asked my polish guy about a clearcoat powder coat on it but he said it would give it a cloudy finish.



Approx. how much does the bar weigh? Ive been toying with the idea for a while, but was concerned a bit about weight and the only pipe i had laying around felt a bit too heavy to use for this application.
* Registered users of the site do not see these ads.
SupaHottSauce is offline   Reply With Quote