View Single Post
Old 03-24-2010, 11:03 PM   #15
amalgrover
Scooby Specialist
 
Member#: 183480
Join Date: Jun 2008
Chapter/Region: South East
Location: Valdosta, GA
Vehicle:
2011 Audi A3 Quattro
2009 Forester XT

Default

if you are really determined to relocate the oil cooler, why not just install an aftermarket setup? It still uses the oil filter sandwich adapter, but it just uses it to run lines to an oil cooler that is mounted at the front of the car. This would give you ultimate cooling capability, but...like everyone else said...why do you need to cool your oil that much. Your car will actually run worse if the oil is not hot enough. You will find yourself blowing all kinds of oil seals as well as have a lot more blow by in this scenerio...just keep the stock setup unless you are tracking the car on a regular basis.
* Registered users of the site do not see these ads.
amalgrover is offline   Reply With Quote