View Single Post
Old 04-03-2010, 01:50 PM   #4
xxscaxx
Scooby Guru
 
Member#: 86459
Join Date: May 2005
Chapter/Region: Tri-State
Location: Campbell Hall, NY
Vehicle:
2013 BRZ
SWP

Default

Illumination wires

as again stated above, these are the black and red wires on the 08. Im just separating each section up so its easier to find.

Black – ground to wheel
Red – ran through the roll connector (yellow on top and bottom)



run a wire from the bottom of the roll connector (yellow) to the orange illumination wire (if you are using a pioneer HU). Solder in here.

* Registered users of the site do not see these ads.
xxscaxx is offline   Reply With Quote