View Single Post
Old 04-03-2010, 12:50 PM   #5
xxscaxx
Scooby Guru
 
Member#: 86459
Join Date: May 2005
Chapter/Region: Tri-State
Location: Campbell Hall, NY
Vehicle:
2013 BRZ
SWP

Default

PAC wiring

reading through the pac instructions, you only need the two loop wires, red, black, and white.
Red – 12 v
Black – ground
White – to wire through roll connector (grey wire on bottom of roll connector)

Run the red wire from the PAC to a 12v source. I wired it into my pioneer harness.
Note: I did not leave the wire like this, everything was soldered.


ground the black somewhere.

White wire – run behind the dash and up to where the roll connector is, to the grey wire on the roll connector. Hide and place wires strategically so they do not interfere with anything.
* Registered users of the site do not see these ads.
xxscaxx is offline   Reply With Quote