View Single Post
Old 04-08-2010, 11:12 AM   #8
scoobystas
Scooby Specialist
 
Member#: 26568
Join Date: Oct 2002
Chapter/Region: NESIC
Location: Brighton, Mass
Vehicle:
2003 Yellow Bugeye
Version 8-Vf37

Default

what i noticed is that after a reset, my avcs doesn't kick in for like 10mins of driving. I have sorta figured out that i need to drive it, then shut it down, then restart and my avcs will kick in.

maybe i should try to let it idle for 10 and see if it kicks in right as i start pulling off after the idle, we'll see

btw, for me it seems like it needs a tank of gas to learn the long term fuel trims. As fas as IAM goes, if you make a pull and car doesn't see any knock than your IAM should go right up to 16.

your learning view shows lots of pulled timing, and areas of added timing, meaning timing was pulled in the past in those areas. You might wanna tweak your timing buy pulling a degree or two in the areas that show knock, but make sure its very smooth, no steps in timing from one load to another. use the 'timing editor' tool in the romraider forums.
* Registered users of the site do not see these ads.
scoobystas is offline   Reply With Quote