View Single Post
Old 04-23-2010, 07:08 PM   #6
WagonR
Scooby Newbie
 
Member#: 160011
Join Date: Sep 2007
Chapter/Region: NWIC
Location: Oregon
Vehicle:
2010 WRX
Satin White Pearl

Default

FYI - when drilling into the panel for the screw holes; you should wrap electrical tape around the drill bit at the depth that you want to stop drilling. This will a) allow you to gauge how far in the drill bit is, and b) provide some safeguard from drilling too deep.
* Registered users of the site do not see these ads.
WagonR is offline   Reply With Quote