View Single Post
Old 04-24-2010, 11:45 AM   #7
scoobydoo666
Scooby Newbie
 
Member#: 132099
Join Date: Nov 2006
Chapter/Region: E. Canada
Location: Canada
Vehicle:
2012 sti limited
rally blue

Default Day 4:

Quarter panel was back in place 24 welds later, so I began the filler and sanding work to shape back the original form. This is the hardest part because this is a complex shape with lots of angles and edges.




Received my other light and bumper cover. Test fitting the front panels. Realized my left headlight bracket was bent it did not fit good. Bracket ordered.




See the fender tip? here come the hammer again to raise it flush. The hood has to come down a bit also.

sanding halfway done. my wrists hurt... haha!
* Registered users of the site do not see these ads.
scoobydoo666 is offline   Reply With Quote