View Single Post
Old 05-18-2010, 06:17 PM   #8
reddoak
Scooby Specialist
 
Member#: 147628
Join Date: Apr 2007
Chapter/Region: MAIC
Location: Columbia, MD
Vehicle:
2013 Beep beep
it's a Jeep.

Default

Quote:
Originally Posted by SueBaroo View Post
Ok so to pull timing, what needs to be done in the ROM and under what table/options. There are three tables I see which are:

Ignition Timing - Advance
Ignition Timing - Compensation
Ignition Timing - Knock Control
None of the above. Pull 3 degrees of timing out of the base ignition timing table in the area where the car pulls timing anyways. You could pull it from the advance, but since you already have a timing issue.... Pull it out of the base timing.

Post up your learning view, I'm curious to see where it's learned to pull timing already.

When you log, don't bother logging the innovate LC-1 and LM-1, since you don't have them... Also, fuel learning and correction, better off not logging it, and use learning view instead. The more parameters you log, the less data you capture.
* Registered users of the site do not see these ads.
reddoak is offline   Reply With Quote