View Single Post
Old 12-22-2002, 09:36 PM   #1
Murray
Scooby Guru
 
Member#: 11312
Join Date: Oct 2001
Chapter/Region: Tri-State
Location: ghettoville, PA
Vehicle:
2009 Gray
Legacy 2.5i

Default 97L- with 2.5RS motor... management question

im in the middle of my swap, putting a 2.5RS motor in my 97L.

i have the 2.5ECU and wire harness, but the harness is not complete..it was cut at the firewall, and i soldered most of it back together, but its still gota a few wires not connected to anything.
i am still waiting on a few diagrams to be faxed to me.
the 2.5 has to wait to go in untill i get a new throw-out bearing, mine is 106,555 miles old, makes abit of noise..well, made noise, now its a paperweight, lol.
anyway, i was thinking about swapping all the sensors and such from my 2.2 onto the 2.5 and running it off the 2.2 ECU, i also have an S-AFC and S-ITC for further control.
what im wondering is will this work and get the same potential out of the motor as with the 2.5 ECU?
any help would be good. thanks

Murray
* Registered users of the site do not see these ads.
Murray is offline   Reply With Quote