View Single Post
Old 05-26-2010, 01:48 PM   #13
wil06STI
Scooby Specialist
 
Member#: 153228
Join Date: Jul 2007
Chapter/Region: NESIC
Location: Springfield,MA
Vehicle:
02 WRX Fully Built
Sedona Red

Default

Quote:
Originally Posted by quazimoto View Post
I don't use Logworks at all. I run the LC-1 straight from Romraiders logger. It has to be hooked up before the LC-1 is powered on. The just select LC-1 as a plug in and then in the data menu on the let of the logger select LC-1. Make sure you have the shunting plug inserted in the "in" connection for the Lc-1.
You need to double check that both the LM programmer and log works are set to gasoline. I like using log works before launching RR because i can see if the calibration was done correctly and also to make sure if its reading properly. You should try that and check and uncheck the LC1 box a few times.

Wil
* Registered users of the site do not see these ads.
wil06STI is offline   Reply With Quote