View Single Post
Old 12-23-2002, 01:48 PM   #4
Murray
Scooby Guru
 
Member#: 11312
Join Date: Oct 2001
Chapter/Region: Tri-State
Location: ghettoville, PA
Vehicle:
2009 Gray
Legacy 2.5i

Default

Progress Update:

well, i was about to swap wire harnesses, but soon found out that wont work at all, so then i decided best thing to do would be swap intake manifolds, that wont work either, the 2.5 manifold is too wide by about 1/2 inch.
now i have all the harnesses labeled and am going to cut both apart to make one..making the fuel injector harnesses fit, the TPS sensor work, and well, just about every other sensor on the motor..the only ones that are the same are the cam, crank, and oil-PSi, the injectors are slightly dif. shaped, but can make it work.
i will let everyone know how it goes later, but for now im off to work.
* Registered users of the site do not see these ads.
Murray is offline   Reply With Quote