Here is my attempt so far doing the front doors and trunk. Still need to do rear doors and rear deck. Figured I'd post in here instead of starting a new thread. Plus I haven't found any pics done to an 03
Car: 2003 WRX
material used: Raamat BXT, ensolite foam
also installed alpine S-type (coax) in the front w/ kartboy spaces
Ok first, it seems like I have a lot more **** in my doors than everyone else, or people are not worried about covering it up. Both front doors basically look like this:
Tried covering the entire door but couldn't get the panel back on:
Then we applied the ensolite foam to the door panel (about 2-3 layers) instead of the door. Again we were worried about covering moving parts, wires etc. Not sure if this will be as effective???
I had more success doing the trunk
Still kind of a work in progress... comments or suggestions?