View Single Post
Old 07-01-2010, 01:15 PM   #146
Davenow
Scooby Guru
 
Member#: 23676
Join Date: Aug 2002
Chapter/Region: NESIC
Location: de_dust and Orgrimar
Vehicle:
.

Default

meh I wouldn't remove the FMIC< I would just turn the boost up another 2PSI and take advantage of the cooling.

The intake, I would tune the car, and if the fuel trims are stable, I would build some sort of heat sheild for the intake, and keep it.


As for what kind of numbers, you are looking at numbers slightly over a normal stage 2 setup, assuming you run the typical 17-18PSI. With a FMIC I would run 19-20.

But at the normal boost pressures, on an semi high to AVERAGE dyno, you are looking at something in the 220-225 range. Up the boost another 2PSI and you should hit mid to upper 230s no problem (on the same dyno that is).

On a heartbreaker, more like 200. On a WAY high reading dyno, lower 240s.
* Registered users of the site do not see these ads.
Davenow is offline   Reply With Quote