View Single Post
Old 07-05-2010, 07:48 PM   #20
tom@kartboy
NASIOC Vendor
 
Member#: 67
Join Date: Jul 1999
Chapter/Region: SCIC
Location: San Diego, CA
Vehicle:
1999 Outlasting
the competition.

Default

Quote:
Originally Posted by Turn in Concepts View Post
Here's what makes no sense about this part. Get under the car and shake the driveshaft right where that joint is. It moves soooooo much inside that carrier bearing that those little things will do nothing. Even you make that little mount solid the entire driveshaft will still move an inch in either direction. It's all a placebo effect.

Tony
Clint and i talked about this a few years ago, The CNC lathe was sitting pretty for a little bit. We both figured out that its pretty much a useless bling part. So we didnt bother making any. Save your pennies for gas.

T
* Registered users of the site do not see these ads.
tom@kartboy is offline   Reply With Quote