View Single Post
Old 08-22-2010, 11:19 AM   #76
yo_its_ok
Scooby Newbie
 
Member#: 6493
Join Date: May 2001
Chapter/Region: Tri-State
Location: NYC and PA.
Vehicle:
2003 WRX
PSM

Default

I use a snap-on 1" hole tool and some soapy water when cutting into SS to keep the weld area clean and cool the bit. Best bet is to get the hole just right to fit snug, if its too loose, tack on one corner and bring it up, and fill in the "slight" gap you may have.
* Registered users of the site do not see these ads.
yo_its_ok is offline   Reply With Quote