View Single Post
Old 08-27-2010, 02:53 PM   #27
Homemade WRX
Scooby Guru
 
Member#: 33782
Join Date: Mar 2003
Chapter/Region: MAIC
Location: 3MI Racing LLC
Vehicle:
96 bastard child
search FIRST, then PM!!!

Default

Quote:
Originally Posted by Red_Wrx View Post
first thing came to mind was cobb talks about a newly built engine, and motoman expresses his opinion and experience about engines out of a factory already considering that they been "heat treated and tested by the factory" and cobb is considering the teqniques needed for a "virgin" engine never ran. id like to " run it hard" on a newly built engine, however is that logical without heat cycling?
What do you mean 'heat treated and tested by the factory'?

Have you seen factory engine break-ins? I know I've seen a few dyno break-in's on prototypes at one of the GM factories on an FSAE tour. They didn't do anything special and it was rather short to be honest.

To be honest, I would assume it was much like the fore-mentioned method.
* Registered users of the site do not see these ads.
Homemade WRX is offline   Reply With Quote