View Single Post
Old 08-30-2010, 09:22 AM   #15
WhiteKnightSTi
Scooby Specialist
 
Member#: 169250
Join Date: Jan 2008
Chapter/Region: NESIC
Vehicle:
2001 Schweizer 300CB
(wirlybird)

Default

Quote:
Originally Posted by Lspade View Post
How do you guys keep the pipe from rusting inside-out? Do you just stick the tip of a spray paint can in one of the ends and let her rip?
I did not, not sure about Carl.

And yes, some rust builds up on the inside. If I was doing it over again I would try to get paint on the inside and use some RTV sealant on the bolt holes to keep crap out. But honestly I'm pretty sure it'll be years before the bar rusts enough to damage it structurally.

I have also had to repaint it 3x in two years of use. I would recomend that any bar you make gets painted with the toughest stuff you can find (grill paint? Truck bed liner?) Rock chips are a bitch.

If anyone is looking for lightbar ideas I would check out this thread on DI:

http://www.dirtyimpreza.com/forums/s...ead.php?t=2926
* Registered users of the site do not see these ads.
WhiteKnightSTi is offline   Reply With Quote