View Single Post
Old 01-13-2003, 08:42 AM   #14
netZ
Scooby Specialist
 
Member#: 5743
Join Date: Apr 2001
Chapter/Region: Tri-State
Location: nj/nyc
Vehicle:
2007 Kia Optima
gold brick

Default

your idea works as well, how about using 1 relay instead?

Pin 86 is connected to the Remote Start Ignition wire
Pin 87A is 1 of the Clutch switch wire
Pin 30 is the other Clutch switch wire
Pin 85 is your Neutral Sense wire off the ECU

if your vehicle is in gear the Clutch wire is not completed which prevents the starter from kicking in.

if you vehicle is in neutral, the relay stays normally closed... thus the Clutch wires are connected and you are able to remote start the vehicle.

also, you will be able to manual start the vehicle w/o pressing the clutch anymore, a byproduct of doing this setup.

also, be sure to hook up the black/white Neutral Safety wire off the viper unit to either a toggle switch to ground or attach it to the Handbrake. the viper checks this wire b4 iniating the remote start sequence.

netZ

Quote:
Originally posted by mikkyo
bump for safety
* Registered users of the site do not see these ads.

Last edited by netZ; 01-13-2003 at 08:52 AM.
netZ is offline   Reply With Quote