View Single Post
Old 09-03-2010, 01:11 PM   #3
Lboogie
Scooby Specialist
 
Member#: 171611
Join Date: Feb 2008
Chapter/Region: BAIC
Location: Silicon Valley
Vehicle:
2014 FiST
Blk

Default

No need to actually cut any wires, the wires/terminals can be remove from the connectors with some jewelers screwdrivers.

If you have the skills/patience you can document which wire is which on the bugeye harness (+ & - high/low beams, turns, parking lights) & take them out of the bugeye plug.

Then do the same for the male ended plug on the hawkeye headlamp assemblies, and affix the 'old' and 'new' wires together (solder, heatshrink, & tape).
* Registered users of the site do not see these ads.
Lboogie is offline   Reply With Quote