View Single Post
Old 09-07-2010, 05:23 PM   #2
mtcs
Scooby Specialist
 
Member#: 180640
Join Date: May 2008
Chapter/Region: E. Canada
Location: Montreal, Canada
Vehicle:
2000 Drag RSTi
8.96 @ 163

Default

Quote:
Originally Posted by gc8v6 View Post
Does anyone know where I can find the tightening specifications for the arp head studs for my car?

I really don't have the time to do much research, my internet access is very limited right now. thanks for your help!
Same as the Ej257 ARP torque specs...

1) Studs hand tightened to bottom of the block. (Use Moly grease, like what ARP supplys)
2) Put the Head Gasket on
3) Using oem PATTERN not procedure (middles, cross corners, cross corners) tighten in 3-4 torque steps. 15, 30, 55, 85ftlbs
4) Let it sit for about an hour then re-check torque.
* Registered users of the site do not see these ads.

Last edited by mtcs; 09-07-2010 at 06:53 PM.
mtcs is offline   Reply With Quote