View Single Post
Old 09-14-2010, 11:40 PM   #5
00LGTP
Scooby Newbie
 
Member#: 172618
Join Date: Feb 2008
Chapter/Region: Tri-State
Vehicle:
2000 RS
BRP

Default

i compared gaskets and came to the conclusion that my stock RS TB will bolt up, but that stupid IACV passage has to be in the way.

i have a TB spacer, so i block it off on the manifold side, drill a hole/install fitting, run a hose from that fitting to the IM plenum.

done!

cable will be easy, small bracket.

the map sensor!

im going to port out on of the EGR holes, only need about a 1/8" all the way around, polish it up nice and pray i did a good job and that O ring will seal. i can always use sensor save gasket sealer.

bolting it up will be no harder of bolting on another plate to the stock EGR threads and drilling holes with bolts for the map.


you guys know it will work!

if you guys get a chance, let me know what you think about this for the fuel system.

http://www.rs25.com/forums/f13/t1427...-his-hose.html
* Registered users of the site do not see these ads.
00LGTP is offline   Reply With Quote