View Single Post
Old 09-20-2010, 07:02 PM   #1
Bad Noodle
Scooby Specialist
 
Member#: 174442
Join Date: Mar 2008
Chapter/Region: Tri-State
Location: NNJ
Vehicle:
2007 SuperWagon
I don't spell well

Default Can I use a bore gauge on acl coated bearings to measure clearance?

Just want to tripple check. Want to use a bore gauge rather than plasti guage since the bore is more accurate. But will have metal on metal contact during measuring. (probe on bearing) This will probably damange the coating as it's uber flimsy. Should I just stick to the plasti guage or can I go ahead and use the bore gauge?
* Registered users of the site do not see these ads.
Bad Noodle is offline   Reply With Quote