View Single Post
Old 09-22-2010, 01:14 AM   #53
Skidd
Scooby Specialist
 
Member#: 1853
Join Date: Jul 2000
Chapter/Region: TXIC
Location: SA-TX (Hozer expat)
Vehicle:
GC6 Supercharged
STM

Default

A bump with an Update! Thanks to the OP and this thread for saving me some $$$!! I managed to rebuild my joint for under $8.00. In fact, had I know I could have bought the bushings I used at Lows I could have done this fix for under $3.00. I managed to keep it on the Cheap with a tweak to the OPs fix.

My whole rebuild is documented here
http://www.ludicrous-speed.com/wiki/...le_Shifter_Fix

But, the short short version is this.
Ground and punched out the rivet. Drilled and Tapped a hole in the end, and used a bolt to secure it. Thus, re-using the Rivet!!





* Registered users of the site do not see these ads.
Skidd is offline   Reply With Quote