View Single Post
Old 09-22-2010, 11:32 AM   #1
RaineMan
Scooby Specialist
 
Member#: 256727
Join Date: Sep 2010
Chapter/Region: RMIC
Location: SL,UT
Vehicle:
2007 2.5I Wagon
Silver

Default Have Axle-back, now what?

Hey all.

Picked up a low mile used axle-back section from a WRX. From eyeballing it and the stock system under my car it looks like installation should just be a matter of unbolting the old piece and bolting up the replacement. However, I just wanted to be sure I have my ducks in a row, so to speak, before jumping into this.

The car only has 21,000mi, but is 3 years old... so I'm figuring I will need a new gasket to go between the mid-pipe and the axle-back along with two new bolts and associated hardware. I'm not going to count on the installing shop being able to reuse anything from the stock setup.

Any place I can get said gasket other than the dealer? Also, does anyone have specs on the two bolts that attach the mid-pipe to the axle-back?

Thanks!
* Registered users of the site do not see these ads.
RaineMan is offline   Reply With Quote