View Single Post
Old 09-23-2010, 08:01 AM   #811
labcoat
Scooby Specialist
 
Member#: 33629
Join Date: Mar 2003
Chapter/Region: MAIC
Location: it keeps changing ,VA
Vehicle:
03 WRX Wagon
WR Blue

Default

Quote:
Originally Posted by kenliu84 View Post
Hey Ry, thanks for pointing that out, I didn't even think of that. How did your Group N's look, the nuts? Easy to press out or would the mount be significantly messed up if I do use a press?


Ok I used a vice and a socket and a cheater pipe on the the Vice handle. So when you are done getting the studs out you put the bolt in like the stud came out then the saggy butt on then the nut holds it all in place. I was unsure about this assembly but it went together just fine and I have had no problems.

Quote:
Originally Posted by kenliu84 View Post
Hey, you know that metal "cover" in the rear? What if that was removed and the tophat was showing? Would that cover being removed provide enough thread on the bolts for the rear brace?
No it is very thin basically a dust cover.

R-
* Registered users of the site do not see these ads.
labcoat is offline   Reply With Quote