View Single Post
Old 09-23-2010, 09:17 AM   #1
GEE-OTTO
Scooby Specialist
 
Member#: 201277
Join Date: Jan 2009
Chapter/Region: MAIC
Location: Arlington VA
Vehicle:
2009 Legacy GT
OBP

Smile The rallisport racing prototype....Finally

Some quick photos of the finished prototype is a 4-2-1 technically and the layout flows well! This design was chosen because it makes more sense than other the typical UEL on the market.

1 5/8" primaries and 1 3/4" secondaries, 2 1/4" final diameter. Will bolt directly to the 2.5i cat/mid pipe and retains the stock O2 locations. The material is full S304. Catalytic converters are MagnaFlow ceramic double dipped combs (same as OEM) and all bends are mandrel not stretch. Ports are gasket matched and fit over or past the lower driver side engine mount!






The more juicy info is that a few lucky folks will get the pre-production units ahead of the final production units! This will help ease demand and get these in the hands of owners to test and talk.

Help is on the way
* Registered users of the site do not see these ads.

Last edited by GEE-OTTO; 09-24-2010 at 08:22 AM. Reason: adding info
GEE-OTTO is offline   Reply With Quote