View Single Post
Old 01-16-2003, 05:47 PM   #19
AZScoobie
Scooby Guru
 
Member#: 8785
Join Date: Jul 2001
Chapter/Region: SWIC
Vehicle:
02 c_turner@ix.
netcom.com

Default Re: Re-Mapped ECU Learning Trick 10-20hp in 5 seconds :)

Quote:
Originally posted by Vishnu Performance
Just a little trick that has been shown to accelerate the factory ECU's ignition timing learning process.

Background: There is something called "Ignition Advance Multiplier". It represents, by some complicated algorithm, the average learned positive knock correction applied to the ignition maps. It's represented in 1/8th degrees increments. 1 being the lowest and 16 being the highest (1/8 to 2 degrees in absolute terms).

The "happier" (knock free) the car is, the higher the number will be. Conversely, the lower it is, the more knock prone it is. This number, after ECU reset ore ECU swap defaults to 8 and usually creeps up to 16 (if well mapped) through normal driving. Depending on driving characteristics, this can happen within a few hours or a few weeks. Well, here's a way to make it happen in about 5 seconds ....

First: With the car fully warmed up, reset the ECU. This can be done by killing power the ECU or by simply pulling off the neg. battery terminal and pressing the brake pedal for a couple of seconds.

Second: Drive to a nice open road without traffic. Don't go on boost until you get there. Put the car into gear (3rd gear works the best) bring the revs up to 2600rpm. Push the go pedal down slightly so boost stays right around 2-4psi. You will need to MAINTAIN 2500rpm and 2-5psi for approx 5 seconds. You can do this by left-foot braking gently as to prevent acceleration. During these few seconds, the advance multiplier (which you can't see so you'll have to trust me) will go from 8, to 12 and then to 16. Works like a charm. And on our reflashed ECU, is worth an immediate 10-20 horsepower

In an attempt to save a lot of dyno time between reflashes (when the advance multiplier resets itself), I do this little trick after every reflash. In a typical dyno session, it's not unusual to reflash the same car up to 5 times. On the dyno, all I need to do is tell the dyno to hold revs to 2600rpm. Then I just lay on the throttle until I see a few psi of boost... Bingo!

Warning: This little trick artificially speeds up the learning process. This is only a good thing if the re-mapped ECU is mapped properly. If there are trouble-spots where knock is present, this trick will make it even more present. So be careful!

Cheers,
shiv
www.vishnutuning.com

Thanks for the tip Shiv... Wanted to just state that left ft braking while in boost will drain the vac from the brakes power booster. This will cause the brakes to have no power assist.. Wont hurt anything.. just beware that you might not have strong brakes until you get back into vac.. I found this out on my car while doing some road tuning the otherday. Just FYI.

CT
* Registered users of the site do not see these ads.
AZScoobie is offline   Reply With Quote