View Single Post
Old 09-28-2010, 06:49 PM   #11
konmann
Scooby Newbie
 
Member#: 125466
Join Date: Sep 2006
Chapter/Region: Tri-State
Location: Hudson Valley
Vehicle:
2006 WRX TR
SGM

Default

Rex,

I will entertain that option when I have enough time to have both pieces of the down pipe off. I knew I should've had the flanges surfaced after I had them finish welded in the first place.

Any insight into the ideal surface roughness for these flanges if they are to seal with no gasket? I imagine that would be pretty important for some type of "bite" between the mating flanges.

Regards,


Kon
* Registered users of the site do not see these ads.
konmann is offline   Reply With Quote