View Single Post
Old 10-15-2010, 02:00 PM   #3
CarTuned
Scooby Specialist
 
Member#: 42203
Join Date: Aug 2003
Chapter/Region: TXIC
Location: SATX
Vehicle:
2011 WRX
WRB

Default

Here is the HID ballast. Not sure what that second box is...perhaps a relay?


Alright, with the windshield washer funnel and stock intake scoop out of the way, I first installed the bulb and connected the two HId connections (blue & black) to the factory H11 bulb harness.



Next, I installed the backing. Forgot the pic

Ok, so now to mount the ballast. I chose to use a factory wire as my mount. You can see it running along the side of the low beam headlight, and flush to the headlight housing. I ran two large black zip ties under it in a criss-cross pattern. See below.


I then place the ballast over the wire and zipped them up.


Afterwards, I made all the connections and pinched the secret "box" using headlight housing wire and bracket. Worked perfectly.

* Registered users of the site do not see these ads.
CarTuned is offline   Reply With Quote