View Single Post
Old 11-05-2010, 01:40 PM   #2
tom@kartboy
NASIOC Vendor
 
Member#: 67
Join Date: Jul 1999
Chapter/Region: SCIC
Location: San Diego, CA
Vehicle:
1999 Outlasting
the competition.

Default

its aluminum. are they broken or just bent down a bit? i've had good results using a large crescent wrench. just get it snug on the tab and bend it up at the bend point. i dont htink i'd want to use any heat and change the temper of the alum.
* Registered users of the site do not see these ads.
tom@kartboy is offline   Reply With Quote