View Single Post
Old 11-10-2010, 12:44 PM   #15
cjake39
Scooby Newbie
 
Member#: 161269
Join Date: Oct 2007
Chapter/Region: RMIC
Location: Colorado Springs, CO
Vehicle:
2007 STI Limited 247
Urban Gray

Default

This was my solution on Monday...



I was able to get two bolts out with a breaker bar and the right 10mm hex socket. The other two stripped the head out so we welded the hex socket to the bolt head that worked for one. The other one blew out the back of the socket, so a 3/4 wrench fit nicely over it....

We did have to use about a 4-5ft breaker bar. Some tools must be sacrificed for this job apparently. Heat from the welds did the most good to free it up.
* Registered users of the site do not see these ads.
cjake39 is offline   Reply With Quote