View Single Post
Old 11-29-2010, 03:33 AM   #1
BlueDiamondOfMiami
Scooby Newbie
 
Member#: 263806
Join Date: Nov 2010
Chapter/Region: South East
Location: Hollywood,Fl.
Vehicle:
2015 WRX Limited
WRB

Question Some concerns in the engine bay?

After I installed my FP Green I noticed that the Perrin hose connected to the turbo and the hot side tubing of the FMIC was not straight but bent into a small S shape I asked my tuner if that is normal and he said yes then after installing the HKS BOV with the perrin FMIC i noticed that it's just laying on the cylinder head it's super flimsy the only thing holding it together is the perrin silicone hose to the cold side tubing of the FMIC my question is, is there another way of putting the BOV in without the hose it just looks cheap this way here is a picture of my engine bay.Hope you all know what I'm talking about.




Sorry I was unable to flip this pic but you get the idea.
* Registered users of the site do not see these ads.
BlueDiamondOfMiami is offline   Reply With Quote