View Single Post
Old 12-15-2010, 02:40 PM   #71
Britain
Scooby Newbie
 
Member#: 247604
Join Date: May 2010
Chapter/Region: NWIC
Location: Hillsboro, OR
Vehicle:
1974 Porsche 914
1700lb AX Car w/ Spec-C

Default

Couple of updates while the engine is out a shop getting all the exhaust tig welded.

Some of you might have noticed in the previous picture of the radiator that the fan was mounted about an inch from the radiator. Not sure why they built it that way, but I modified the fan mounts to move it about 1/4" from the radiator. This will be much more efficient. I also had some tabs welded on for the mounts to the chassis.



Also made a bracket to hold the three master cylinder reservoirs in the front. I am mounting a Tilton brake pedal assembly and converting the clutch to a hydraulic throw-out bearing hence the need for this set-up.



-Britain
* Registered users of the site do not see these ads.

Last edited by Britain; 10-23-2012 at 02:05 PM.
Britain is offline   Reply With Quote