View Single Post
Old 12-16-2010, 04:04 PM   #5
Tut4u2
Scooby Specialist
 
Member#: 40424
Join Date: Jul 2003
Chapter/Region: MAIC
Location: PA
Vehicle:
Its a boat
on jack stands

Default

9. Let the new seal soak in place fluid before you put them in.

10. Clean off the pistons and install the new dust boots. Pull down the dust boots until they are FLUSH as seen above. The following is what YOU DO NOT WANT IT TO LOOK LIKE.

11. Soak the piston in fluid.

12. Simply push the piston back in like described above.
13. Move to the other piston.
14. Close the bleeder valves.
15. Clean off the caliper.
16. You're done!
* Registered users of the site do not see these ads.

Last edited by Tut4u2; 12-16-2010 at 04:49 PM.
Tut4u2 is offline   Reply With Quote