View Single Post
Old 01-22-2011, 12:10 AM   #2
Kontankerous
Scooby Newbie
 
Member#: 257551
Join Date: Sep 2010
Chapter/Region: South East
Location: LaGrange, GA
Vehicle:
2011 WRX
Satin White Pearl

Default

Step IV:
There are 6 points of contact that I found that cause the rattle.
1-4 are the rear edge of the plastic shelf, it has 4 fins that are covered in an adhesive foam. You can see that it's worn through from rubbing the metal shelf underneath. i pointed out the spots on the metal shelf where you can see the rubbing from the plastic fins on the bottom of the plastic cover.










5 is the trailing edge of the plastic shelf where it touches the glass.



6 is the keyless module; it's a small metal clip suspending the module slightly above the metal shelf, the thin metal support flexes quite a bit allowing the module to vibrate against the metal. Remove this with a 10mm socket.

* Registered users of the site do not see these ads.
Kontankerous is offline   Reply With Quote