kpluiten's Build Thread: A Tale of Procrastination
View Single Post
01-25-2011, 12:27 PM
Now with 100% more Spec-C
Next I did the Group-N trailing arm lower bushings in the rear hubs. The process was very similar to the lateral links and again I used a funnel tool. I had the hub apart already so there was plenty of room to work. Others have made tools to do the install while the hub is assembled or on the car. My funnel tool went from 45.5mm to 40mm over a 4° taper.
of the site do not see these ads.
View Public Profile
Find More Posts by kpluiten