View Single Post
Old 03-16-2011, 03:04 PM   #1
PhatBotti Tuning TKR
NASIOC Vendor
 
Member#: 239659
Join Date: Feb 2010
Chapter/Region: Tri-State
Location: Tri-State / California
Vehicle:
STI Mikey & Phatron
Tuning Da Subies

Default

PhatBotti Tuning & Alliance Fabrications 2002 WRX GTX35 2.5L Build
I've had this car since 2001. Im just gonna throw up some progression pucs over the last 10 years....to where we're at today.

PhatBotti Tuning teamed up with Alliance Fabrication for the most recent GTX35, caging, wilwood brakes...portion of the build

Final Build Mods

GTX35 w/ Tial 0.82
Alliance Fabrications v-band header and up
Alliance Fabrications downpipe
Alliance Fabrications cold air intake
Alliance Fabrications modded Spearco (this will be changed to a fmic after break in)
Alliance Fabrications chromoly 8 million point roll cage
Alliance Fabrications Flatbottom
DSS Carbon Fiber Driveshaft
NRG Carbon Fiber Drivers Seat
NRG 5 Point Harness
NRG Steering Wheel
PPG 6 Speed Dogbox
Wilwood Rotors & Pads with Alliance Fabrications Top Hats
Aeromotive Fuel Cell with A1000 and surge tank built in
Five-0 1600 cc injectors
Cosworth Intake Manifold
Cobb AP running Speed Density
Konig Lightweight Wheels
Lexan Windows
Lotsa Weight Reduction

Motor Parts

ej257 Case Halves - 11008AA930
11mm Oil Pump - 15010AA360
Gasket Set - 10105AA590
Nitrided Crank - 12200AA430
Rear Access Panel (big) - 11831AA210
Screws (x7) – 800406140
Locking Screws (x1) – 800406150
Bolt (x6) - 800708620
Seal Ring-Cylinder B Lock (x4) - 10991AA001
O-Ring (x1) - 806932030
Bolt (x1) 800708630
Bolt (x1) 800706500
Cover-Service Hole (x1) 11093AA000
Plug -Cylinder Block (x3) 11021AA020
Cover-Oil Separator (x1) 11831AA210
Cylinder Head Case RH - 11039AB910
Cylinder Head Case LH - 11063AB330
Valve Cover RH - 13264AA340
Valve Cover LH - 13278AA270
Wiseco Pistons (standard 99.5mm) - K598M995
Manley Turbo Tuff I-Beam Rods - MAN-14416-4
ARP L19 Head Studs
Brian Crower Stage3 280 Cams for EJ257
ACL race Main bearings - standard oil clearance (5M8309H)
ACL race Rod bearings - +1 oil clearance (4B8296HX)
supertech +1mm intake valves
supertech +1mm inconel exhaust valves
supertech dual valve springs, TI retainers, seats














* Registered users of the site do not see these ads.

Last edited by PhatBotti Tuning TKR; 07-09-2012 at 11:36 PM.
PhatBotti Tuning TKR is offline   Reply With Quote