View Single Post
Old 04-11-2011, 06:45 PM   #11
101101
Scooby Newbie
 
Member#: 260658
Join Date: Oct 2010
Chapter/Region: South East
Location: Raleigh, NC
Vehicle:
2011 STI Sedan
WRB

Default

Over the weekend I did this but when I took off my shelf I didn't have as much wear as you do (there was some wear). I did the foam on the contact points to play it safe but also put the soft side of velcro on all plastic pieces (C pillar components) where plastic-on-plastic contact would occur. If you do it right, you can't see the velcro once the pieces are installed.

These two things combined eliminated all squeaks / rattles from the rear of my sedan.
* Registered users of the site do not see these ads.
101101 is offline   Reply With Quote