View Single Post
Old 04-13-2011, 08:58 PM   #25
RP31
Scooby Specialist
 
Member#: 123574
Join Date: Aug 2006
Chapter/Region: MWSOC
Location: Lisle, IL
Vehicle:
2005 2.6L 9:1 425WHP
CGM STi

Default

It should be pretty difficult to screw up the cam by drilling the bolt. First, you're drilling with a drill bit that has a smaller diameter than the bolt itself. Second, you should not be drilling far enough into it to get anywhere near the cam. You only have to drill to slightly below the surface of the cam pulley, which is still a good distance away from the cam.
* Registered users of the site do not see these ads.
RP31 is offline   Reply With Quote