View Single Post
Old 04-15-2011, 06:06 AM   #7
KOJAK-02-WRX
Scooby Specialist
 
Member#: 208052
Join Date: Apr 2009
Chapter/Region: MWSOC
Location: Southern Indiana
Vehicle:
2004 SGM FXT-6speed
*SOLD* 02 PSM WRX

Default

Thanks, I hope it helps someone. I am looking into finding some 7075 to replace the 6061 turnbuckle tube that I have above. I am also looking into front and rear endlinks.


You can also trade the AHT12-15.00 for a AHT12-14.00 and cut 0.5" less on each end and be able to get the full 15.5 to 16.5" adjustment. I used the 15 since it left less unused threads since they are tapped 2.5" deep on both sides.

Also I found out that the STi links are longer then the RS links I believe 405mm (not proven but close to the 16" measurement I have) compared to 415mm (proven) so if you are making them for an STi you would want to cut only 1.14321" from each end to make the factory length at the center of the adjustment. This will make your adjustment from 15.83-16.83".
* Registered users of the site do not see these ads.

Last edited by KOJAK-02-WRX; 04-15-2011 at 06:17 AM.
KOJAK-02-WRX is offline   Reply With Quote