View Single Post
Old 04-15-2011, 11:20 AM   #8
patricksmith04
Scooby Specialist
 
Member#: 116816
Join Date: Jun 2006
Chapter/Region: MAIC
Location: Maryland
Vehicle:
2011 WRX
Silver

Default

Quote:
Originally Posted by mrkyle3 View Post
I have described how to fix it multiple times on here and this is EXACTLY how I fixed it. Great pictures! The way the wire was routed through those clips put too much tension in the wire so I just unhooked it from the clips and that loosened it right up.

I can vouch for it working, I fixed it about 600 miles ago and it's still working great

By the way, a suggestion when doing this is to put your hazards on. That way you can constantly see how your turn signal is working as you are working on it. When I loosened the slack it didn't fix it at first, I also had to physically push the wires back into the bulb harness and then the bulb lit right back up to normal brightness
Thanks for your PM. It helped, but as I described, my wires weren't held by any metal clips, just plastic clips you could easily see.

Nonetheless, glad you could help me out! Thanks again.
* Registered users of the site do not see these ads.
patricksmith04 is offline   Reply With Quote