View Single Post
Old 04-19-2011, 02:35 PM   #17
KOJAK-02-WRX
Scooby Specialist
 
Member#: 208052
Join Date: Apr 2009
Chapter/Region: MWSOC
Location: Southern Indiana
Vehicle:
2004 SGM FXT-6speed
*SOLD* 02 PSM WRX

Default

Quote:
Originally Posted by Storm View Post
Yes....it is cool.....

Jay
If you look in this picture paranoid you will see that he had to cut his rear cross member in order to gain access to the jam nuts on teh inside. This is a problem on these diy setups which is why i changed to a center adjust setup.

The jam nuts are all there just everything adjusted to the shorted position. Also it still has the right and left hand threads so you just use a wrench on the very center section to adjust length just the same as Version 1, but now it is only a 1/2 wide instead of the whole length. I'll put a all the way extended drawing to show it a little better.
* Registered users of the site do not see these ads.
KOJAK-02-WRX is offline   Reply With Quote