View Single Post
Old 04-21-2011, 01:15 AM   #52
Visconti
NASIOC Vendor
 
Member#: 156247
Join Date: Aug 2007
Chapter/Region: NESIC
Location: Norwalk, CT
Vehicle:
14' Flex Fuel FXT
15' Flex Fuel WRX

Default

Been busy over here but finally have made some nice progress with Stock ECU Speed Density.

My biggest worry with SD was temperature change.

I always found that when I ran my AEM ECU the a/f's would move around.

Even with adjusting settings it just was never right.

Currently EcuTek's Speed Density's a/f's are very consistent on temp change.

Right now I'm maxing out DW1000 Top Feed Injectors w/ my DW300 Pump on 20Psi.

I had planned on putting Top Feed 1600's in over the weekend but had clearance issues. The injectors I'm running need adapters and they're not clearing my agency power fuel rails .

Any how here's a little video of me beating up my car over the weekend.

* Registered users of the site do not see these ads.

Last edited by Visconti; 04-21-2011 at 01:20 AM.
Visconti is offline   Reply With Quote