View Single Post
Old 05-16-2011, 08:07 PM   #5
O.C.D.
Scooby Specialist
 
Member#: 19640
Join Date: Jun 2002
Chapter/Region: RMIC
Location: Colorful CO
Vehicle:
2005 RBP LGT 5T WAG
Cryotuned Stage 1

Default

Feed the gauge wires through the grommet and then you are ready to wire the gauges.

I used the rubber bands provided from the SMY Cluster and then wrapped them with some electrical tape. This gives a very tight fit but has some give to move the gauges.

Here is the stock cluster with the SMY Cluster:
\

Notice the stock cluster and the two part construction:


Notice the SMY Cluster and the one piece construction:


* Registered users of the site do not see these ads.
O.C.D. is offline   Reply With Quote