View Single Post
Old 05-18-2011, 01:55 PM   #1730
Scooby Specialist
Member#: 216858
Join Date: Jul 2009
Chapter/Region: MWSOC
Location: Central Iowa
2009 Impreza OBSlow
Steel Silver/Spark Silver


Originally Posted by imprzya View Post
Best way to lay film, graphics, etc is to spray the surface with water mixed with a lil bit of car wash soap and then you can move the film around until it is in the right place then use a hard plastic edge and a hair dryer get the bubbles out. Not the best explaination, sorry, hope you have better luck next round!

Yeah, had all of that going for me, but these outside lenses are just a complete b*tch! Given the surfuce "designs", it is almost impossible to get it to lay flat and stick without wrinkling. I know people have done it as I have seen the "after" results - just not up close I guess. Just got so frustrated with that one!
* Registered users of the site do not see these ads.
Eric91Z is offline   Reply With Quote