View Single Post
Old 05-23-2011, 01:14 AM   #12
Trigg
Scooby Newbie
 
Member#: 151781
Join Date: Jun 2007
Chapter/Region: MWSOC
Location: Madison
Vehicle:
2011 STI Sedan
DGM

Default

Quote:
Originally Posted by 101101 View Post
Over the weekend I did this but when I took off my shelf I didn't have as much wear as you do (there was some wear). I did the foam on the contact points to play it safe but also put the soft side of velcro on all plastic pieces (C pillar components) where plastic-on-plastic contact would occur. If you do it right, you can't see the velcro once the pieces are installed.

These two things combined eliminated all squeaks / rattles from the rear of my sedan.
Also did this this weekend, but im having problems with the lower piece of the panel below that is closest to the windshield not staying "clipped" in place. I used the quotations, because all i can see are two little notches that i guess are supposed to hold it in?? To clarify what im talking about, its the section in the upper right corner of this photo.

* Registered users of the site do not see these ads.
Trigg is offline   Reply With Quote