View Single Post
Old 06-20-2011, 11:08 AM   #1
Vew
Scooby Specialist
 
Member#: 74229
Join Date: Nov 2004
Chapter/Region: MAIC
Location: Morgantown, WV
Vehicle:
2004 PSM WRX
2000 Outback Sdn

Default Removing Melted Plastic from Bumper

My exhaust must have shifted in the past few years or something, but I have a small quarter sized carbon spot from where my bumper came in contact with my hot exhaust tip and melted it on there. Cooked it to a carbon spot over a years time. It's a stainless exhaust from Perrin.

Anyone have any suggestions? I could scrape it off.. possibly. Doubt it would work well and not sure if it'd scratch the surface. I could also blow torch it. Something not too hot like a propane torch, not Mapp or anything. Unsure if that would do anything either.

Edit: I meant removing melted plastic from bumper on my exhaust.
* Registered users of the site do not see these ads.
Vew is offline   Reply With Quote