View Single Post
Old 07-01-2011, 02:33 AM   #545
WRXcket
Scooby Newbie
 
Member#: 275605
Join Date: Mar 2011
Chapter/Region: NWIC
Location: Seattle
Vehicle:
2011 WRX Hatch
DGM

Default

Quote:
Originally Posted by xluben View Post
Oh, good idea. Didn't think of that. I think the other side is a matte finish, right? I'm not sure if those little clips will survive being pulled out, though. They seemed like the one-time-use type of thing.
The other side has an identical finish, just no logo. Assuming you remove the protective plastic cover, that is

Good point about the plastic thingies, not sure whether or not they'd hold up.

One more tip that I just remembered - go find some locking nuts to replace the wing nuts that hold your fairing on. They're not theft-proof, but at least a little more difficult to remove than the wingnuts. A buddy of mine got his stolen a week after installing it. I found some stainless nylock nuts at Home Depot for mine.
* Registered users of the site do not see these ads.
WRXcket is offline   Reply With Quote