View Single Post
Old 07-03-2011, 10:35 AM   #546
xluben
Scooby Guru
 
Member#: 261612
Join Date: Oct 2010
Location: Minneapolis, MN
Vehicle:
2002 WRX Sedan
10.9s @ 126mph

Default

Quote:
Originally Posted by WRXcket View Post
The other side has an identical finish, just no logo. Assuming you remove the protective plastic cover, that is

Good point about the plastic thingies, not sure whether or not they'd hold up.

One more tip that I just remembered - go find some locking nuts to replace the wing nuts that hold your fairing on. They're not theft-proof, but at least a little more difficult to remove than the wingnuts. A buddy of mine got his stolen a week after installing it. I found some stainless nylock nuts at Home Depot for mine.
On my fairing it appears the rear side is less glossy than the front (logo) side. I still haven't tried anything because I'm afraid the little plastic clips will get ruined. Thanks for the tip on bolting on the fairing. I think I will have to do that. The hand-tighten hardware they include is convenient, but also leaves it wide open for theft.
* Registered users of the site do not see these ads.
xluben is offline   Reply With Quote