View Single Post
Old 07-04-2011, 05:29 AM   #6
e85monster
Scooby Newbie
 
Member#: 271529
Join Date: Jan 2011
Default

This is the very first day I brought the car home from the dealership. Brand new 2007 2.5i outback sport.


After a couple years of owning the car I didnt do too much. I baked the head lights, put a lip on it, rear WRX wing and a $10 set of dyno ridges for the back


A good friend of mine and I were talking about doing a full build on my car but we werent sure exactly how we could do it. After talking to a couple of local tuners and thinking it out we started.

IMAG0028 by imprezagic, on Flickr

The stock block hanging from the chain.

IMAG0032 by imprezagic, on Flickr

After getting all the internals for the motor we were ready to build. The STI EJ257 crank with eagle H beam rods

IMAG0008 by imprezagic, on Flickr

empty EJ257 short block...not for long lol

IMAG0007 by imprezagic, on Flickr

After plasti gaging the the crank with the bearings and rods we started to put it together

IMAG0009 by imprezagic, on Flickr

sorry for the blurry picture. The crank and rods in one half of the block.

IMAG0010 by imprezagic, on Flickr

After installing the rods and crank it was time for the CP pistons. With this engine we did a 100mm over bore so the block came out to basically be a 2.6L

IMAG0013 by imprezagic, on Flickr

The CP pistons!!

IMAG0014 by imprezagic, on Flickr
* Registered users of the site do not see these ads.

Last edited by e85monster; 07-04-2011 at 05:46 AM.
e85monster is offline   Reply With Quote